Assuming that the input to Simulink is a function called input_signal(t)
, where t
is the simulation time, and that the Simulink model is already built, we can use the following code to execute the simulation three times with a randomly chosen input signal between 0.1 and 2.5:
main.m743 chars17 lines
This code uses a for
loop to execute the simulation three times, with a randomly chosen input signal each time. Inside the loop, we define the input signal as a function of time, set the simulation time horizon, and simulate the system using the sim
command. Finally, we create a plot of the output using stairs
, with a subplot for each simulation. The title of each subplot indicates the simulation number and the chosen input amplitude.
gistlibby LogSnag