design a elevator system in matlab in matlab

main.m
% Define system parameters
N_floors = 2; % Number of floors
floor_height = 3; % Height of each floor (m)
car_speed = 4; % Elevator car speed (m/s)
car_capacity = 10; % Elevator car capacity
car_position = 1; % Initial position of the elevator car (floor 1)

% Define control algorithm
while true
    % Check if there are any requests on this floor
    if floor_request(car_position)
        % Open doors
        open_doors();
        
        % Wait for passengers to board
        while car_load() < car_capacity && floor_request(car_position)
            wait();
        end
        
        % Close doors
        close_doors();
        
        % Move elevator car to next floor
        if car_position == 1
            car_position = 2;
        else
            car_position = 1;
        end
        
        % Wait for elevator car to arrive at destination floor
        while car_position ~= floor_request_taker(car_position)
            wait();
        end
    else
        % Move elevator car to next floor in the direction of requests
        if floor_above() && (car_position == 1 || car_load() == 0)
            car_position = 2;
        elseif floor_below() && (car_position == 2 || car_load() == 0)
            car_position = 1;
        else
            % Stop elevator car
            wait();
        end
    end
end

% Define helper functions
function [above, below] = floor_request(car_position)
    % Return true if there are any requests at the current floor
end

function [above, below] = floor_above()
    % Return true if there is a request above the current floor
end

function [above, below] = floor_below()
    % Return true if there is a request below the current floor
end

function [load] = car_load()
    % Return the current number of passengers in the car
end

function [] = open_doors()
    % Open the elevator doors
end

function [] = close_doors()
    % Close the elevator doors
end

function [] = wait()
    % Wait for a short duration before checking again
end

function [dest_floor] = floor_request_taker(current_floor)
    % Return the destination floor for the current passenger request
end
2129 chars
79 lines